Burks 330CS7M-SS Turbine Pump, Close Coupled, 60 Hz, Three Phase, 3450/2850 RPM, 3 Horsepower, ODP Motor Enclosure, 72 lbs.
|Casing Material||316 Stainless Steel|
|Casing Working Pressure||250|
|Discharge NPT (Inches)||1|
|Frame Material||316 Stainless Steel|
|Heads To (Feet)||350|
|Impeller Material||303 Stainless Steel|
|Inlet Pressure (PSI)||100|
|Maximum Operating Temperature||225°F (107°C) - Standard Buna-N Seal|
|Motor Enclosure Type||ODP - Open Drip Proof Enclosure|
|Motor Shaft Material||303 Stainless Steel|
|Raceway Material||303 Stainless Steel|
|Shaft Seal Material||Carbon / Ceramic / SS Buna-N|
|Suction NPT (Inches)||1.25|
|Burks CS Stainless Steel Series - Regenerative Turbine Pumps, Close Coupled|
|Materials of Construction|
|Frame - Bronze Fitted: Cast Iron, All Bronze: Bronze, Stainless Steel: #316 Stainless.|
Case - Bronze Fitted: Cast Iron, All Bronze: Bronze, Stainless Steel: #316 Stainless.
Impeller - Bronze Fitted: Bronze, All Bronze: Bronze, Stainless Steel: #303 Stainless.
Raceway - Bronze Fitted: Bronze, All Bronze: Bronze, Stainless Steel: #303 Stainless.
Shaft: #303 Stainless
Shaft Seal: Carbon Ceramic SS Buna-N
|Standard pump motors have open drip proof construction and are rated with jet pump service factors for continuous duty operation at all ratings shown. Single phase motors are capacitor start/induction run with buitin overload protection. Three phase motors require a magnetic type starter which provides full 3-leg overload protection. Failure to use the correct starter and overloads will void the warranty.|
|Every pump factory tested|
Single Phase motors are 115/208-230 Volt, 60 Hz, 1750 RPM
Three Phase motors are 208-230/460 Volt, 60/50 Hz, 1750/1450 RPM
Single Phase motors are 115/208-230 Volt, 60 Hz, 3450 RPM
Three Phase 1, 1 1/2 & 2HP - 208-230/460 Volt, 60/50 Hz., 3450/2900 RPM
Three Phase 3 & 5 HP - 208-230/460 Volt, 60 Hz, 3450 RPM
|Jacketed Seal Cavity|
|For Temperature to 500°F (260°C) - Series CS Pumps are available in a Jacketed Seal Cavity design for pumping hot oil, hot water and heat transfer fluids in common use in high temperature heating or cooling applications. This feature greatly extends seal life in high temperature applications. To order, add suffix “J” to pump catalog number for temperatures below 400°F (204°C) and add suffix “JK” to pump catalog number for temperatures over 400°F (204°C). Example: 15CS5MJ.|
You need to sign in to add a review.
Stay tuned for releases of new product reviews and videos on our YouTube channel!
Check our Social Media for new product announcements and exclusive specials for our followers.