Image shown may not be actual product
LMI Pumps P031-297 Series P Metering Pump, 0.42 GPH @ 110, 115 Volt, 50/60 HZ,
LMI Pumps P031-297 Series P Metering Pump, 0.42 GPH @ 110, 115 Volt, 50/60 HZ,
Connections / Discharge (Inches) | Pipe 1/4" NPT M |
Diaphragm | Fluorofilm |
Flow Control | Single Manual Control |
Head / Fittings | 316 SS / 316 SS |
Hz | 50/60 |
Includes | Instruction Manual |
Maximum Flow (GPD) | 10.08 |
Maximum Flow (GPH) | 0.42 |
Maximum Pressure (PSI) | 110 |
Maximum Strokes Per Minute | 60 |
Maximum Viscosity (CPS) | 400 |
Product Notes | New LMI PD Series Replacement Pump, PD041-927NP Upgrade From P031-297 |
Turn Down Ratio | 600:1 |
Valve Balls | 316SS |
Valve / Seat / O-Ring | 316SS / PTFE |
Voltage | 115 |
General Description |
---|
LMI Roytronic Series P chemical metering pumps shall be positive displacement, Liquifram type pumps that are UL and CUL approved. Output volume shall be adjustable while pumps are in operation from zero to maximum capacity. |
Pump Controls |
The stroke frequency will be fixed. Stroke length shall be adjustable by a readily accessible dial knob located opposite the liquid handling end. |
Drive Assembly |
The pump drive shall be totally enclosed with no exposed moving parts. Electronics shall be housed in chemical resistant enclosure at the rear of the pump for maximum protection against chemical spillage. Electrical power consumption shall not exceed 22 watts per hour under full speed and maximum pressure conditions. Pump weight shall not exceed 7.6 lbs (3.5 kg). |
Pressure Relief |
The LMI 4-Function Valve is recommended with a LiquiPro or AutoPrime Liquid End to provide automatic pressure relief. |
Materials of Construction |
Chemical metering pump housing shall be of chemically resistant glass fiber reinforced thermoplastic. All exposed fasteners shall be stainless steel. Valve seat and seal ring shall be renewable by replacing only the combination seat-seal ring or cartridge valve assembly. |
Check Valve / Tubing Connections |
A total of 16 ft (4.8 m) of tubing shall be provided per pump complete with compressing connections on models with tubing connections. A foot valve with integral one piece strainer shall be provided for the suction line, and an injection check/back pressure valve with 1/2" NPT male connection for the injection point. The injection check valve shall incorporate a dilating orifice which prohibits scale formation and accumulation of crystalline deposits. |
Chemical Metering
39812 productsStay tuned for releases of new product reviews and videos on our YouTube channel!
Check our Social Media for new product announcements and exclusive specials for our followers.
0 Reviews
Add a Review
You need to sign in to add a review.