Image shown may not be actual product

3100WG6-2

0 reviews

Burks 3100WG6-2 Centrifugal Pump, Self Priming, 60 Hz, Three Phase, 3500 RPM, 10 Horsepower, ODP Motor Enclosure, 215 lbs.

$5,355.00

Best Price Guarantee!
1071PumpPoints

Item: 3100WG6-2

Repair Parts Exploded View Diagram

Overview
Series Info
Reviews
Literature/Manuals
Repair Parts

3100WG6-2

Burks 3100WG6-2 Centrifugal Pump, Self Priming, 60 Hz, Three Phase, 3500 RPM, 10 Horsepower, ODP Motor Enclosure, 215 lbs.

Adapter Material	Cast Iron
Capacities (GPM)	280
Casing Material	Cast Iron
Casing Working Pressure	200
Discharge NPT (Inches)	2
Heads To (Feet)	178
HP	10
Hz	60
Impeller Material	Bronze
Inlet Pressure (PSI)	100

Material	Bronze Fitted
Maximum Operating Temperature	225°F (107°C) - Standard Buna-N Seal
Motor Enclosure Type	ODP - Open Drip Proof
Motor Shaft Material	316 Stainless Steel
Phase	3 Ph (Three Phase)
Shaft Seal Material	Carbon / Ceramic / SS Buna-N
Speed (RPM)	3500
Suction NPT (Inches)	2
Voltage	230/460

WG6-2 Series Information

General Description
Burks WG6-2 Series - Centrifugal Pumps, Self Priming
Materials of Construction
Adapter - All Iron: Cast Iron, Bronze Fitted: Cast Iron Casing - All Iron: Cast Iron, Bronze Fitted: Cast Iron Casing Wear Ring - All Iron: Steel, Bronze Fitted: Bronze Impeller - All Iron: Cast Iron, Bronze Fitted: Bronze Shaft: #316 Stainless Steel Shaft Seal: Carbon Ceramic SS Buna-N
Shaft Sleeve Information
Gasketed and keyed hook-type sleeve protects shaft from wear and corrosion in seal area.
Motors
JM Type motors have NEMA standard mounting flange, extended steel shaft and dual bearings. These motors offer the advantage of quiet operation, controlled shaft deflection for longer seal life, and bearings sized to provide good service life. All motors are supplied by manufactures with national field service facilities. Flapper and check valves on the suction pipe are not required, but are recommended.
Mechanical Shaft Seal Information
Standard self-adjusting shaft seal for temperatures up to 225°F (107°C) and pressures to 150 psi (1034kpa). Ceramic seat and carbon seal face for long trouble-free service. Special seals are available for higher temperatures and fluids other than water.
Factory Tested
After careful assembly and inspection, EVERY pump is factory tested and will meet Hydraulic Institute standards.
Motor Information
60 Hz - 3500 RPM - ODP Three Phase: 5, 7-1/2 & 10 Hp. - 230/460 Volt
Overload Protection
All motors must be installed with a magnetic starter which provides full 3-leg protection. Failure to use correct starter and overloads will void motor warranty.
Enclosed Bronze Impeller
Enclosed Bronze Impeller is of the latest hydraulic design for maximum effi ciency. It is balanced for vibration-free operation. It is precision fit to shaft with key drive and cap screw lock.
Casing Information
Casing is close grain iron of 30,000 psi minimum tensile strength. Back pull-out design eliminates the need to disturb piping should the pump ever require service - the casing stays in the line.